Skip to content
English
Sign in
  • There are no suggestions because the search field is empty.

Replacement of motor driver 5

This article describes how to replace motor driver 5 on the HORST1000G2.

DANGER!

Danger resulting from incorrect commissioning

⇒ Commissioning must be performed only by persons with technical and electrotechnical training who were also authorized by fruitcore robotics!

 

  1. Shut down the robot and disconnect it from the power grid.

  2. Loosen the screws marked in yellow.

  3. Carefully disconnect all plug connections on the motor driver and loosen the fastening screws.


  4. Insert the new motor driver with the cooling pads and tighten the screws to a torque of 0.8 Nm. Then reconnect all plug connections.
  5. Fit the cover and tighten the screws to 5 Nm.